Wand Emulation Plug & Play; Rs-232 - Honeywell 4820HDHM User Manual

RS-232

The RS-232 Interface barcode is used when connecting to the serial port of a
PC or terminal. The following RS-232 Interface barcode also programs a car-
riage return (CR) and a line feed (LF) suffix, baud rate, and data format as indi-
cated below. It also changes the trigger mode to manual.
Option
Baud Rate
Data Format
Wand Emulation Plug & Play
In Wand Emulation mode, the image scanner decodes the barcode then sends
data in the same format as a scanner image scanner. The Code 39 Format
converts all symbologies to Code 39.
The Same Code Format transmits UPC, EAN, Code 128 and Interleaved 2 of 5
without any changes, but converts all other symbologies to Code 39.
The Wand Emulation Plug & Play Code 39 Format barcode below sets the
terminal ID to 61. The Wand Emulation Plug & Play Same Code Format bar-
code sets the terminal ID to 64. These Plug & Play barcodes also set the Trans-
mission Rate to 25 inches per second, Output Polarity to black high, and Idle
State to high. (If you want to change the terminal ID only , without changing any
other image scanner settings, please refer to
Terminal ID Method
Wand Emulation
Plug & Play
(Code 39 Format)
2 - 2
Setting
115200 bps
8 data bits, no parity bit, 1 stop bit
RS-232 Interface
on page 2-6.)
Programming the Interface -
Wand Emulation
Plug & Play
Same Code