Connecting The 3G Card - Cisco 881W - Integrated Services Router Wireless Hardware Installation Manual

Chapter 3 Connecting the Router
Make sure that your modem and the router auxiliary port are configured for the same transmission speed
Step 4
(up to 115200 bits per second [b/s] is supported) and support mode control with data carrier detect
(DCD) and data terminal ready (DTR).

Connecting the 3G Card

The Cisco 880G router does not support OIR of the 3G card. You must enter the shutdown command on
Note
the cellular interface before you remove the 3G card from the router.
To connect and secure the 3G card, follow these steps:
Align the 3G card to the 3G express card slot, as shown in
Step 1
surface and firmly push the card into the slot.
Tip
Note
Note
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-03
Holding the 3G card on the flat metal surface will make it easier to align and insert the 3G card.
When inserting the card into the 3G express card slot, you may hear a metal-on-metal sound as
the 3G card rubs against the internal metal cage. The 3G card is designed to fit tightly into the
3G express card slot. Firm pressure may be required to insert the card.
Global System for Mobile Communications (GSM) customers need to insert a SIMM card,
provided by their network carrier, into the 3G card.
Connecting the 3G Card
Figure 3-7. Keep the card parallel to the
3-9