Cisco 881W - Integrated Services Router Wireless Hardware Installation Manual page 21

Chapter 1 Product Overview
Figure 1-6
1
2
3
4
5
1. Depending on the router model, the primary WAN port can be G.SHDSL, VDSL2oPOTS, or 10/100 FE. The VDSL2oPOTS
Caution
Cisco 880 Series Voice Routers
The Cisco 880 series voice routers provide managed voice services that interface with Foreign Exchange
Station (FXS), Foreign Exchange Office (FXO), or Basic Rate Interface (BRI) connections.
Figure
available vary, depending on the router model. Some features may not be available on your router.
Depending on the router model, the primary WAN port can be either G.SHDSL or 10/100 FE. See the
Cisco 880 Series Integrated Services Routers
supported on your router.
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-03
Back Panel of the Cisco 888EG Data Router
1
3G Diag port
1
Primary WAN port —RJ-45 only, G.SHDSL,
VDSL2oPOTS, ADSL2+oPOTS,
ADSL2+oISDN, or 10/100 FE
Antenna—captive omnidirectional dipole
WLAN antenna (wireless models only)
4-port 10/100 Ethernet switch
Serial port—console or auxiliary
port is in the same location as the G.SHDSL port. The 10/100 FE WAN port is located at the bottom left corner. See
for location of the 10/100 FE WAN port.
The primary WAN port is designed for an RJ-45 connector only. Damage to the primary WAN
port may occur if a non RJ-45 connector is inserted.
1-8, and Figure 1-9 show the features available on the Cisco 880 series voice routers. The features
2 3
6 PoE power connector—optional
7 Reset button
8 Power connector
9 Earth ground connection
10 Kensington security slot
data sheet for the WAN interface and voice ports that are
Cisco 880 Series ISRs
4 5 6 7 8 9 10
Figure 1-2
Figure 1-7,
1-7