Cisco WIP310 - iPhone Wireless VoIP Phone Administration Manual page 180

Configuring Dial Plans
About Dial Plans
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
When a user lifts a handset or presses a speaker button on the IP phone, the
following sequence of events begins:
1. The phone begins collecting the dialed digits. The inter-digit timers starts
tracking the time that elapses between digits.
2. If the inter-digit timer value is reached, or if another terminating event occurs, the
phone compares the dialed digits with the IP phone's dial plan. (This dial plan is
configured in the web administration user interface in the Voice tab, on the tab
for each extension (Ext N), under the Dial Plan section.)
If the phone is part of a Cisco SPA 9000 system:
3. If the phone dial plan allows the call to process, the dialed numbers are sent to
the Cisco SPA 9000.
4. The Cisco SPA 9000 compares the dialed digits to the CALL ROUTING RULE (on
the SPA 9000 Voice > SIP page, PBX Parameters section).
5. If the call routing rule allows the call to process, then the Cisco SPA 9000
compares the dialed digits to the LINE INTERFACE dial plan (on the Cisco SPA
9000 Voice > Line N page, Dial Plan section).
6. The Cisco SPA 9000 uses the information in the line dial plan to manipulate the
number (for example, to remove steering digits) and then transmits the number.
Refer to the following topics:
• "Digit Sequences," on page 170
• "Digit Sequence Examples," on page 172
• "Acceptance and Transmission of the Dialed Digits," on page 174
• "Dial Plan Timer (Off-Hook Timer)," on page 175
• "Interdigit Long Timer (Incomplete Entry Timer)," on page 176
• "Interdigit Short Timer (Complete Entry Timer)," on page 177
8
169