Advanced; Network - D-Link SECURICAM Network DCS-2100G User Manual

Wireless internet camera
Hide thumbs Also See for SECURICAM Network DCS-2100G:
Table of Contents

Advertisement

DCS-2100G User's Manual

Advanced

The Advanced tab provides the following configuration options: Network, Mail & FTP,
DDNS & UPnP, Video, Image Setting, and Motion Detection.

Network

Reset IP Address
at next boot:
IP address:
Subnet mask:
Default router:
Primary DNS:
Secondary DNS:
HTTP Port:
Control channel
Audio channel
Video channel
D-Link Systems, Inc.
Once the DCS-2100G is configured, this box should be
unchecked at all times. If the box has been checked and the
connection is lost, run the Installation Wizard to find the
camera's IP address.
Necessary for network identification.
Used to determine if the destination is in the same subnet. The
default value is "255.255.255.0."
The router used to forward frames to destinations in a different
subnet. Invalid router settings may cause the failure of
transmissions to a different subnet.
Primary domain name server that translates names to IP
addresses.
Secondary domain name server to backup the primary one.
Can be set to other than the default port 80. When the
administrator changes the HTTP port of the DCS-2100G (which
has an IP address of 192.168.0.100) from 80 to 8080, users
must type http://192.168.0.100:8080 in the Web browser bar.
Can be set to other than the default port 5001 to correspond
port:
with the port opened by the firewall.
Can be set to other than the default port 5002 to correspond
port:
with the port opened by the firewall.
Can be set to other than the default port 5003 to correspond
port:
with the port opened by the firewall
Using the DCS-2100G with an Internet Browser
47

Advertisement

Table of Contents
loading

Table of Contents