Wiring For Dry Contact Relay Outputs - Honeywell HW-AV-LTE-M Installation And Operation Manual

Honeywell Connected Life Safety Services | Honeywell Connected Life Safety Services
01.
Connect the panel to the communicator as specified in
02. Power up the system as specified in

5.7.1 WIRING FOR DRY CONTACT RELAY OUTPUTS

The communicator can be wired to monitor dry contact relay outputs. This wiring is done without connecting to a dialer interface.
CAUTION: WIRING RESTRICTIONS
ALL WIRING MUST BE WITHIN A CONDUIT.
DO NOT USE RESETTABLE POWER TERMINALS.
Wiring for Dry Contact Relay Outputs
Installation and Operation Manual | REV. B
Powering On.
Figure 5-1: Wiring for Dialer Capture
Panel Terminal Panel Connector
AUX +
GND -
PRIMARY DIALER RING
TIP
BACKUP DIALER RING2
TIP2
Wiring for Dialer Capture.
Pathway
Connection
+
-
RING
TIP
RING2
TIP2
17 Wednesday, February 28, 2024