Honeywell Connected Life Safety Services | Honeywell Connected Life Safety Services
5.5 MOUNTING PROCEDURE
01.
In the Quick Start Guide, locate the installation sticker at the bottom right of the last page.
02.
Check that the sticker has the serial number and the configuration key to program the communicator.
03.
Place the sticker on the inside lid of the enclosure for programming steps and for future reference.
04.
Mount the HW-AV-ENC enclosure on the wall next to the fire panel using the wall mounting holes.
05.
Mount the enclosure onto the two mounting holes as shown in
it with the supplied hardware.
06.
Slide the CLSS Pathway onto the mounting studs and secure with the hex nuts provided in the enclosure kit.
5.6 INSTALLING THE ANTENNA
5.6.1 INSTALLATION CONSIDERATIONS
Do not use a damaged antenna with the communicator. Replace the damaged antenna immediately.
l
Use only a manufacturer approved antenna. Non-approved antennas or modifications could impair service quality, damage the
l
device, and violate FCC regulations.
A location below the ground level or a metal structure may impact the network coverage.
l
Installation and Operation Manual | REV. B
Figure 5-1: Mounting the CLSS Pathway into the Enclosure
Mounting the CLSS Pathway into the Enclosure
15
and secure
Wednesday, February 28, 2024