Honeywell NOTIFIER NFS2-640 Operation Manual page 59

Remote Terminal Access
Control Functions
C.2.2 Local Monitor Mode (LocM)
Functions, passwords, and special requirements of Local Monitor Mode (LocM) are:
Functions:
Passwords:
Requirements:
Functions available with the Local Monitor Mode:
Read Status
Alter Status
Control Functions
C.2.3 Remote Terminal Mode (RemT)
Functions, passwords, and special requirements of Remote Terminal Mode (RemT) are:
Functions:
Passwords:
Requirements:
68
Function
• Acknowledge.
• Signal Silence.
• System Reset.
• Drill.
Table C.1 Local Terminal Mode Functions (2 of 2)
Read Status, Alter Status, and Control Functions (Table C.2).
User-defined password for Alter Status and Control functions.
Password security feature for Control Functions eliminates the need for mounting the
CRT-2 in an enclosure.
Function
• Display the status of an individual point (Detector, Module, or Zone).
• Display a list of all the points in Alarm or trouble.
• Display a list of all programmed points in the system.
• Step through the History buffer event by event.
• Display the entire History buffer.
• Step through Alarm History
• Display the entire Alarm History
• Disable/Enable an individual point.
• Change the sensitivity of a detector.
• Clear the verification counter of all detectors.
• Clear the entire History buffer.
• Set the Intelligent Sensing alert and action levels.
• Acknowledge
• Signal Silence
• System Reset
• Drill
Table C.2 Local Monitor Mode Functions
Read Status only. See Table C.3.
None
Use with UL ITE-listed terminals, including personal computers with the VeriFire™
Tools or terminal emulation software. Intended for terminals connected through
modems, including FSK modems connected through a public switched telephone
network.
Lets you...
Lets you...
NFS2-640 Operations P/N 52743:L4 06/10/19
Operating Modes