Makita DUC150Z Instruction Manual page 11

2.
Turn the lever counterclockwise until the sprocket
cover comes off.
Fig.9
► 1 . Lever 2. Sprocket cover
3.
Remove the sprocket cover.
4.
Align the hole on the guide bar with the pin on the tool
body, and then place the guide bar as shown in the figure.
1
3
Fig.10
► 1 . Guide bar 2. Hole 3. Pin
5.
Slide the guide bar toward the sprocket to lock the pin.
1
Fig.11
2
► 1 . Guide bar 2. Pin
1
2
2
11 ENGLISH
6.
Remove the guide bar from the tool body.
7.
Check the direction of the saw chain. Match the
direction of the saw chain with that of the mark on the
tool body.
1
Fig.12
► 1 . Mark on tool body
8.
Fit one end of the saw chain on the top of the
guide bar.
9.
Fit the other end of the saw chain around the
sprocket, then attach the guide bar to the tool body so
that the hole on the guide bar is aligned with the pin on
the body.
Fig.13
► 1 . Sprocket
Press the guide bar against the tool body to release the
pin. The saw chain tension is automatically adjusted.
3
1
Fig.14
► 1 . Saw chain 2. Pin 3. Sprocket
1
2