How To Use - Makita UT001GM102 Instruction Manual

HOW TO USE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
NOTICE:
When you are not working, lay the
machine down and store it.
Fig.5
Assembly
Installing the shaft
Optional accessory
For UT001G
1. Tighten the shaft into the shaft holder.
1
Fig.6
► 1 . Shaft 2. Shaft holder
2.
so that the shaft holder cannot revolve. With the flats
held so, tighten the hex nut with another wrench 19 in
the direction of arrow.
Fig.7
► 1 . Shaft 2. Shaft holder
For UT002G
1.
Fig.8
► 1 . Shaft 2. Chuck
2.
chuck key in each of three holes and tighten it clock-
wise. Be sure to tighten the chuck key at all three holes
evenly.
2
Fig.9
► 1 . Chuck key 2. Chuck
3.
terclockwise at one of the holes, and then loosen the
chuck by hand.
8 ENGLISH
Hold the flats on the shaft holder with wrench 19
1
Insert the shaft into the chuck as far as it will go.
1
Tighten the chuck by hand, and then place the
1
To remove the shaft, turn the chuck key coun-
2
2
2