Makita DUH507SF Instruction Manual page 12

Installing or removing the chip
receiver
Optional accessory
CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
NOTICE:
The blade cover cannot be installed if
the chip receiver is installed on the tool. Before
carrying or storing the tool, uninstall the chip
receiver, and then install the blade cover to avoid
exposure of the shear blades.
NOTICE:
Be sure to remove the blade cover
before installing the chip receiver.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
1. Align the holes on the chip receiver with the
screws on the shear blades.
1
Fig.19
► 1 . Screw
2. Hook the claws of the chip receiver to the groove
on the shear blades.
Fig.20
► 1 . Claw 2. Groove
3. Press the levers on the chip receiver, and then
hook the claws on the other side to the groove on the
shear blades.
Make sure that all the claws are hocked in the groove of
the guide bar firmly.
Fig.21
► 1 . Lever 2. Claw
To remove the chip receiver, press the levers to release
the claws.
Fig.22
► 1 . Lever
1
NOTICE:
by an excessive force with its hooks locked to the
shear blades.
2
2
12 ENGLISH
1
Never try to remove the chip receiver
2
1
1