Names Of Parts; Introduction Of Separately Sold Items; Preparation; Turning The Power On/Off - Makita RM350D Instruction Manual

5. The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements.
For commercial transports e.g. by third parties or forwarding
agents, special requirement on packaging and labeling must be
observed.
For preparation of the item being shipped, consulting an expert
for hazardous material is required. Please also observe possible
more detailed national regulations.
6. Do not use the machine near high-voltage electrical power
transmission lines. Doing so may result in a malfunction or
breakdown of the machine or battery.
7. Store the product in a safe place out of the reach of children.
8. Never service damaged battery packs. Service of battery
packs should only be performed by the manufacturer or autho-
rized service providers.
SAVE THESE INSTRUCTIONS.

Names of parts

► Fig.2
1. Robotic Mower
2. "STOP" button
3. Display cover
4. Rear wheel
5. LED
6. Charging socket
7. Control panel
8. Top cover
9. Chassis
10. Slider shaft
11. Rubber retainer
12. Front wheel
13. Power switch
14. Grip
15. USB cap
(Do not open. This is for maintenance servicing.)
16. Blade cover
17. Blade base
18. Mower blade
19. Skid plate

Introduction of separately sold items

CAUTION: These accessories or attachments are recom-
mended for use with your Makita products specifi ed in this
manual. The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory or attach-
ment for its stated purpose.
For details of separately sold items, refer to the catalog or contact the
dealer or our sales offi ce.
• Blade set
— Set of mower blades and fi xing screws

PREPARATION

The following preparations are needed to use this product.
1. Preparing the work area
Determine the range to be mowed by the Robotic Mower. Enclose the
work area with the boundary wire, and connect the power supply to
the charging station. Install a guide wire as necessary.
For the detailed procedure, refer to the enclosed Setup Guide.
2. Initial setting of the Robotic Mower
When using the Robotic Mower for the fi rst time, it is necessary to set
the language, date and time, mowing area, and PIN code.
For the detailed procedure, refer to the enclosed Setup Guide.

3. Charging the Robotic Mower

The battery of the Robotic Mower is not charged suffi ciently when
factory-shipped. Charge the battery before use.
For the charging procedure, refer to the section "Charging the Robotic
Mower" (Page 16) in this manual.
CAUTION: Only use genuine Makita batteries. Use of
non-genuine Makita batteries, or batteries that have been altered,
may result in the battery bursting causing fi res, personal injury and
damage. It will also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum battery life
1. Never recharge a fully charged battery. Overcharging short-
ens the battery service life.
2. Charge the battery with ambient temperature at 10 °C - 40 °C
(50 °F - 104 °F). Let a hot battery cool down before charging
it.
3. Charge the battery if you do not use it for a long period
(more than six months).
20. Charging station
21. Station base
22. Charging terminal
23. Terminal cover
24. Station housing
25. Station indicator
26. Wire cover
27. Boundary wire
28. Guide wire
29. Wire
30. Peg
31. Connector
32. Coupler
33. AC adapter
(The plug shape will diff er from region to region.)
34. Cabtire cable
35. Screw peg
(For fi xing the charging station)
36. Hex wrench 6
• Wire
• Wire repair kit
— Set of wire, couplers, and pegs
• Peg
• Coupler
NOTE: Some separately sold items in the list may be supplied
with the machine as standard accessories at the time of purchase.
Standard accessories may diff er depending on the country of
purchase.
Turning the power on/off
The power switch is located on the underside of the Robotic Mower.
Press the side of the power switch to turn on the power, or
the side to turn off the power.
► Fig.3: 1. Power switch
Charging the Robotic Mower
Checking the remaining battery capacity
1. Press the "STOP" button.
The display cover opens.
► Fig.4: 1. "STOP" button 2. Display cover 3. Control panel
2. Turn on the power switch of the Robotic Mower.
3. Press the button on the control panel.
The [Main menu] appears. You can check the remaining battery
capacity at the upper right of the screen.
16 ENGLISH