RCD (Residual Current Device). Under no circumstances put a plug on the cable. Failure to comply with these safety instructions will release Buffalo from any responsibility and the warranty will become null and void. • Position on a flat, stable surface.
Page 3
• This is an Attended Appliance and must be supervised when in use. • Switch off after use. • If Oil begins to Smoke or Overheat then Switch Off Immediately. • Caution! Hot surface! • DO NOT immerse the appliance in water. •...
• Instruction manual BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Installation Warning: Incorrect installation, operation, maintenance or cleaning of the equipment, as well as any modification can cause property damage and personal casualty. Fully read and understand all instructions before installation. Before installation and operation, it is the user’s responsibility to ensure that all Health &...
Operation Model shown: CU476 Oil tank Lifting mechanism Heating indicator light Heating element Overheat indicator light Reset switch Drainage tap Thermostat with on/off function Note: Before using for the first time, clean all parts well. Let dry completely. Assembly • Position the heater of the fryer in place.
Thermal Cut-out Reset The appliance is fitted with a Thermal Cut-Out safety switch. Should the temperature exceed safe levels the appliance will automatically cut off power. The thermal Cut-out switch is located on the front of the unit. To reset the appliance after a sufficient cool-down period: 1.
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Buffalo. Every effort is made to ensure all details are correct at the time of going to press, however, Buffalo reserves the right to change specifications without notice.