RCD (Residual Current Device). Under no circumstances put a plug on the cable. Failure to comply with these safety instructions will release Buffalo from any responsibility and the warranty will become null and void. • Position on a flat, stable surface.
Page 3
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities. • If the power cord is damaged, it must be replaced by a Buffalo agent or a recommended qualified technician in order to avoid a hazard.
• Instruction manual BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Electrical wiring DANGER of electric shock from incorrect connection There is a danger to life if the wires are incorrectly connected. Connection to a suitable power supply should only be carried out by a qualified and competent electrical engineer. Warning: The fixed wiring of the power cord connection must be equipped with a disconnect device (leakage protection switch) with a contact distance greater than 30mm according to the wiring rules.
Overheat indicator light Reset switch Cooking Note: BUFFALO recommend the cooking surface is lightly oiled before cooking. 1. Turn the appliance On at the mains power supply. 2. Set the thermostat to the desired temperature (50°C-300°C). The heating indicator light comes on and the appliance begins to heat up.
Thermal Cut-out Reset The appliance is fitted with a Thermal Cut-Out safety switch. Should the temperature exceed safe levels the appliance will automatically cut off power. The thermal Cut-out switch is located on the front of the unit. To reset the appliance after a sufficient cool-down period: 1.
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Buffalo. Every effort is made to ensure all details are correct at the time of going to press, however, Buffalo reserves the right to change specifications without notice.