Hammer; Disassembling - Makita DTD155 Repair Manual

6-4

Hammer

6-4-1

Disassembling

Fig. 15
1R045
[1]
[2]
Fig. 16
Fig. 17
[3]
[1]
[4]
Fig. 18
[3]
[1]
[3]
[1]
[3]
[1]
[2]
[4]
[2]
1
Turn the handle of 1R045 clockwise to push Spindle [1]
and compress Compression spring 21[2].

Set 1R045 on Hammer [3] so that the protrusions of
Hammer [3] and the claws of 1R045 cross at a right
angle.

Align the opening for Steel ball insertion with the top
of Cam groove on Spindle [1] by turning 1R045.
1R045 should be held securely by hand so that the claws of
1R045 do not slip off.
2
Remove two Steel balls 4.8 [1] by inserting a slotted
screwdriver magnetized by 1R288.
3
Turn 1R045 counterclockwise to loosen Hammer [2] and
then take out Spindle and related parts [1] from Hammer
[2] and remove Compression spring 21 [3] and Washer 21
[4].
When removing Spindle [1] from Hammer [2], place them
with Hammer [2] side down so that Steel balls 3 (24 pcs) do
not fall down.
4
Spindle section can be disassembled into Flat washer 12
[1], two Pins 3.5 [2], two Spur gears 17 [3] and Spindle [4].
9 / 26
Tip
Note
Tip