Assembling - Makita DTD155 Repair Manual

6-6-2

Assembling

1
Assemble by reversing the disassembly
procedure.
Fig. 38
[1]
Projection of Statorl
Fig. 39
[1]
[3]
Fig. 40
2
Projection of Statorl
.
[2]
3
[2]
4
[1]
16 / 26
Fix Sensor board [1] of Controller with three PT 2x6
Tapping screws.

The orientation of Sensor board [1] matters. The black
sensor element side should face towards Stator [2].

Holes of Sensor board [1] and two projections of Stator
[2] should be engaged.
Insert Rotor [1] into Stator [2].
Push the drive-end of Rotor [1] against workbench.
Insert Rotor [1] into Stator [2] by lifting up Stator [2] slowly.

Before assembling, blow off iron powder from Rotor [1]
with an air duster to prevent abnormal rotation.

Don't insert Rotor [1] forcefully into Stator [2] because
Sensor board [3] may get broken.
Connect three Straight terminals to Terminal [1] as follows:
 + (left).........Red
 AS (center) ...Yellow
 - (right) ........Black
Tip
Tip
Note