Hammer Case; Assembling - Makita DTD155 Repair Manual

6-5

Hammer case

6-5-1

Assembling

Fig. 26
[3]
[2]
[1]
Groove
Fig. 27
[6]
[1]
[4]
Fig. 28
[3]
[5]
[5]
[2]
[1]
[3]
[5]
[1] [2]
[4]
1
Assemble Nylon washer 19 [1] and Anvil M [2] to
Hammer case [3].
Apply Makita grease FA No.2 to the groove on the surface of
Anvil M [2].
2
Install Internal gear 43 [1] on Bearing box [2], and then
install Hammer section [3] on Internal gear 43 [1].
Apply Makita grease FA No.2 to the following portions:

Surface of two Spur gears 17 [4]

Top hole of Spindle [5]

Surface of Hammer [3] surrounding Spindle [5]

Check that O ring 33 [6] is inserted in Bearing box [2].

Check that Hammer section [3] rotates without
wobbling.
3
Holding Anvil M [2], install Hammer case [1] on Hammer
section [3]. And then assemble them to Bearing box [4].

Engage concave portions of Hammer case [1] and
convex portion of Internal gear 43 [5].

If the projections of Hammer [3] interfere with the
T-shaped anvil portion of Anvil M [2], turn Anvil M
together with Hammer case a little to engage Hammer
case section and Internal gear section completely.
12 / 26
Tip
Tip
Note
Tip