Makita VC2211M Technical Information page 6

R
epair
[3] DISASSEMBLY/ ASSEMBLY
[3]-1. Motor section (cont.)
ASSEMBLING
(1) Assemble the parts shown in Fig. 14.
Note: Loosely tighten M8 Hex nut to Armature shaft.
(2) Install Fan cover onto the assembly you made in step (1) as follows:
1. Put the assembly on 1R023 so that it stands on *the six protruding ribs of Base. (*See Fig. 15.)
2. Put Fan cover on the assembly.
3. Put 1R258 on Fan cover. (Fig. 16)
Note: Do not to put 1R258 on the three mating bosses of Base, or you will break them.
4. Using arbor press, press-fit Fan cover onto Return vane. (Fig. 16)
Fig. 14
Fig. 15
six protruding ribs
(3) Push Rubber ring 120 firmly into the groove of Base
with the groove side up as shown in Fig. 17.
Note: When installing the assembled parts to
Separator complete, be sure to apply 5g of
ThreeBond 1215 in the groove of Rubber ring
120 without gap.
(4) Attach Field to Endbell.
Fig. 16
Base
Return vane
Fig. 17
Rubber ring 120
P 6/ 21