Makita VC2211M Technical Information page 18

W
iring diagram
2. Wiring in Separator complete
Fig. D-9
rib
Place Lead wires
and Vinyl tube
between the boss
and the inside wall
of Separator complete.
inside wall of
Separator complete
Push Vinyl tube over
Pressure sensor of
Controller firmly
until it stops.
This space is for holding
two
Closed end splices
(Connector 2-SD).
Do not put any slack of
the other Lead wires.
Do not place the slack of Lead wires
on this portion.
boss
Controller
boss
Sub controller
Do not place the slack of Lead wires
on these ribs.
Flag terminals
(with sleeves)
P 18/ 21