Makita VC2211M Technical Information page 5

Hide thumbs Also See for VC2211M:

epair

[3] DISASSEMBLY/ ASSEMBLY

[3]-1. Motor section (cont.)

DISASSEMBLING

(10) Disconnect Carbon brushes from the commutator of Armature assembly by moving the tail end of the spiral spring

of each Brush holder as shown in Fig. 10.

Note: No need to remove Carbon brushes in this step.

(11) Unscrew M4x12 Pan head screw that fastens Brush holder to Endbell, then remove Terminal of Field ass'y from

the terminal of Brush holder, and then remove Brush holder together with Carbon brush.

(12) Remove Endbell and Field by unscrewing two M5x60 Pan head screws.

(13) Remove Fan cover from Return vane as follows; put a slotted screwdriver against Fan cover as shown in Fig. 11,

then tap the screwdriver with a plastic hammer.

Fig. 10

(14) Remove Fan 125 from Armature shaft as follows; hold Armature firmly with a gloved hand,

then remove M8 Hex nut by turning counterclockwise with an impact driver.

(15) Remove Return vane from Base as follows; loosely tighten M8 Hex nut to Armature shaft

so that Armature assembly cannot fall out of Base, then put a slotted screwdriver against

Return vane as shown in Fig. 12, and then tap the screwdriver gently with a plastic hammer.

Shown in Fig. 13 is the exploded view of Return vane-Armature assembly section.

Fig. 12

Fig. 13

Fig. 11

Put a slotted screwdriver

against Return vane

through the notch of Base.

P 5/ 21

Table of Contents