Makita VC2211M Technical Information page 3

R
epair
[3] DISASSEMBLY/ ASSEMBLY
[3]-1. Motor section
DISASSEMBLING
(1) Unlock two hooks to separate Motor section from Tank section. (Fig. 2)
(2) Raise Grip and open Base hook, then remove nine 4x35 Tapping screws to remove Base grip and Cowling complete
from Separator complete. Switch base E-M complete can be now be removed. (Fig. 3)
(3) Remove Receptacle terminals of Field from Controller. (Fig. 4b)
(4) Remove Vinyl tube from the hole beside DC motor unit. (Fig. 4a)
(5) Remove seven 4x35 Tapping screws (five screws fastening Separator complete to Tank cover complete and
two screws fastening DC motor unit to Tank cover complete). (Fig. 4)
(6) Remove DC motor unit from Tank cover complete. (Fig. 5)
Note: Be careful not to drop Spindle assembly out of DC motor unit.
DC motor unit can be disassembled as shown in Fig. 6.
Fig. 2
Hook
Fig. 4
Fig. 4a
Fig. 5
Fig. 3
Hook
Fig. 6
DC motor unit
Cowling complete
Separator complete
viewed from top
Fig. 4b
Controller
DC motor
Gear case
M3x6 Pan head screw (2 pcs)
Flat washer 12
Spur gear 15 [of plastic] (3 pcs)
Spur gear 9 complete
Spur gear 15 [of steel] (3 pcs)
Internal gear 42
Ball bearing 6805LLB
Flat washer 34
Spindle assembly
P 3/ 21
Grip
Base grip
Receptacle terminals