Parts Description - Makita DCU602 Instruction Manual

CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.

PARTS DESCRIPTION

When the bucket is installed
► Fig.1
1 Tilt switch
5 Rear lamp
9 Rear wheel
13 Front wheel
When the carrier is installed
► Fig.2
1 Tilt switch
5 Rear lamp
9 Rear wheel
13 Front lamp
ASSEMBLY
CAUTION:
Always be sure that the machine
is switched off and the battery cartridges are
removed before carrying out any work on the
machine.
Before installing or removing the carrier or bucket, be
sure to lock the brake lever. To lock the brake lever, pull
and hold the brake lever, then pull the lock lever, and
then release the brake lever while pulling the lock lever.
► Fig.3: 1. Brake lever 2. Lock lever
Installing or removing the bucket
Installing the bucket
1. Take out the bucket, stays, and front pipe from the
box.
► Fig.4: 1. Bucket 2. Stay 3. Front pipe
2. Insert the front pipe between the upper frame and
lower frame of the dump unit.
► Fig.5: 1. Front pipe
2 Control panel
6 Handle
10 Rear wheel lock
14 Front lamp
2 Control panel
6 Handle
10 Rear wheel lock
14 Carrier
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
3 Beep button
7 Battery box
11 Lock lever
15 Bucket
3 Beep button
7 Battery box
11 Lock lever
- -
3.
Place the stay on the dump unit, and then tempo-
rarily tighten the bolts with the front pipe together. Install
the other stay to the dump unit in the same way.
► Fig.6: 1. Stay 2. Bolt
4. Place the bucket on the front pipe and left and
right stays.
Place the rubber washer on the hole of the bucket and
insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
► Fig.7: 1. Bolt 2. Rubber washer 3. Flat washer
4. Spring washer 5. Nut
5.
Securely tighten 4 bolts which were temporarily
tightened in step 3.
Removing the bucket
To remove the bucket, perform the installation proce-
dure in reverse.
22 ENGLISH
4 Switch trigger
8 Brake lever
12 Dump unit
- -
4 Switch trigger
8 Brake lever
12 Front wheel
- -