Maytag MFS25PN Service Manual page 41

NO PROCESS
Message:
Explanation:
Solution:
OUT OF BALANCE
Message:
Explanation:
Possible causes:
Possible solutions:
OVERLOAD FAULT
Message:
Explanation:
Possible causes:
"NO PROCESS" is displayed for a few seconds.
This happens when a non-programmed wash cycle is selected and
the "Start" keypad pressed.
Enter an existing process number.
"OUT OF BALANCE" is displayed.
Non-Cabinet type and soft-mount type washing machines are
equipped with a safety switch, which prevents the machine from
operating while the load is out of balance. When the washing
machine gets out of balance, extracting stops immediately. The
laundry is automatically redistributed in the drum and the washing
machine starts extracting again. However, if the washing machine
gets out of balance approximately eight times in a row. "OUT OF
BALANCE" appears on the display and the buzzer sounds.
• Badly distributed laundry in the drum.
• The load is either too large or too small
• Broken suspension or out of balance switch not properly adjusted.
• Redistribute the laundry in the drum.
• Take out or put in some more laundry.
• If the suspension is broken, contact your commerical distributor.
0
If the problem has been solved, you may continue from "SELECT
PROCESS--".
"OVERLOAD FAULT" appears on the display and the buzzer sounds.
This happens when the motor has become thermally overloaded or
the motor contactor is overloaded. All other machine functions are
switched off.
•The motor may be overheated, the motor may have failed due to
high current.
Possible solutions: • Allow the motor to cool down, if the motor has failed, consult your
commercial distributor.
16009607
To cancel message: Press "Stop" to stop the buzzing. When the
problem has been solved, press "Start" to continue.
CAUTION
Except as necessary to perform a particular step in servicing a product, the
electrical power supply should ALWAYS be disconnected.
©1999 Maytag Appliances Sales Company
Section 4. Troubleshooting
4-5