Section 3. Programming And Set-Up Procedures; Touchpad Functions - Maytag MFS25PN Service Manual

SECTION 3. PROGRAMMING AND SET-UP PROCEDURES
For more information other than what is listed in the section, please see Programming
and Operating Manual MKllA-20 Controller, part number 16007856. This manual can be
obtained from your commercial distributor or Maytag Appliances Sales Company -
Customer Service, 240 Edwards St. SE, Cleveland, TN 37311.
TOUCHPAD FUNCTIONS
During the wash process it is possible to check certain details by pressing certain keypads. A
brief description of these keypad functions are given below.
TIME+
16009607
TEMPERATURE AND WATER LEVEL KEYPAD
If this keypad is pressed, the programmed temperature and water level is displayed for
the current step in the process. In addition, the temperature and water level that is
actually reached is shown.
FUNCT. (Function) KEYPAD
The currently active function of the current step in the process is displayed.
SERVICE KEYPAD
Shows the number of cycles the washing machine has already completed. "CYCLES
XXXX" is displayed. You are also given the number of times that a particular error has
occurred.
PROG. (Program) KEYPAD
Enter a process number for "SELECT PROCESS - -".
By pressing "Prag." you get an overview of the whole process.
TIME
+
KEYPAD
This keypad enables you to extend the time of the current step of the process. This
function only works if you answered "Yes" to the question "MANUAL OVERRIDE ?" in the
initialization mode.
ADV (Advance) KEYPAD
This keypad enables you to shorten the time of the current step of the process. This
function only works if you answered "Yes" to the question "ALLOW ADVANCE?" in the
initialization mode.
Pressing this keypad rapidly twice, enables you to skip over any current step of the
process, except the steps "EXTRACT'' and "SPRAY," if "Yes" was answered to the "Allow
Advance?" message during the initialization mode.
IMPORTANT NOTE:
THE "ADV" KEYPAD DOES NOT WORK WITH THE "EXTRACT," HIGH SPIN," "SPRAY
RINSE" AND "SPRAY FLUSH" FUNCTIONS.
STOP KEYPAD
It may be necessary to stop the execution of all functions during the wash cycle. You
can do this by pressing the "Stop" keypad.
1. To stop the process temporarily and then restart from the step where the interruption
occurred. If you have pressed "Stop," "STOP PRESSED" will appear on the display for
a few seconds, followed by "RE-START ?". You may now continue from "RE-START ?"
Section 3. Programming and Set-Up Procedures
©1999 Maytag Appliances Sales Company
3-1