Table of Contents
Advertisement
3. Disconnect water service and drain
connection to machine.
4.
Remove back panel(s).
5.
Remove v-belts from basket pulley.
6.
Mark location of pulley on basket shaft
and remove basket pulley. This will
require removing a
2-1/2"
diameter snap
ring first (See Figure 2-10), straightening
the locking tab (See Figure 2-11) on the
washer underneath the locking nut, and
using an HN13 spanner wrench to remove
the clamping nut on tapered sleeve (See
Figure 2-12). Using pulley sleeve tool
(See Figure 2-13), drive the sleeve toward
the front of the machine (See Figure 2-14
and 2-15) and then slide the pulley off the
basket shaft. (See Figure 2-16 and 2-17).
Note:
Space
between too
Remove lock nut
Figure2-12
lock
Nut
Snap Ring
Remove snap ring
pulley
collar forward
Figure2-10
Bend lock tab back
Figure2-11
16009607
Figure2-13
Figure2-14
Section 2. Service Procedures
©1999 Maytag Appliances Sales Company
2-14
Advertisement
Table of Contents
