Removing The Mulching Plug - Makita LM004G Instruction Manual

NOTE: Make sure that there is no gap between the
lower handle and the mower body after the clamping
levers are folded.
Fig.6
2. Align the hole in the upper handle with the hole
in the lower handle, then insert the bolt from outside,
and then tighten the thumb nut from inside. Perform the
same procedure on the other side.
2
1
Fig.7
► 1 . Thumb nut 2. Bolt
NOTE: Hold the upper handle firmly so that it does
not drop off your hand.

Removing the mulching plug

1. Open the rear cover.
Fig.8
► 1 . Rear cover
2. Hold the mulching plug by the handle, and then
pull it out from the mower body as shown in the figure.
Fig.9
► 1 . Handle 2. Mulching plug
Installing or removing the grass basket
To install the grass basket, follow the steps below.
1. Open the rear cover.
Fig.10
► 1 . Rear cover
2.
Hold the handle of the grass basket, and then hook the grass
basket on the rod of the mower body as shown in the figure.
Fig.11
1
► 1 . Rod 2. Handle 3. Grass basket
To remove the grass basket, open the rear cover, and
then remove the grass basket by holding the handle.
10 ENGLISH
1
2
1
1
3
2