ENGLISH (Original instructions) SPECIFICATIONS Model: LM003J LM004J Mowing width (blade diameter) 480 mm 534 mm No load speed Normal mode 3,200 min 2,800 min Soft no-load mode 2,500 - 3,200 min 2,300 - 2,800 min Noise reduction mode 2,500 min...
The vibration total value (tri-axial vector sum) deter- and electronic equipment, accumulators mined according to EN62841-4-3: and batteries may have a negative impact on the environment and human health. Model LM003J Do not dispose of electrical and electronic Vibration emission (a ) : 2.5 m/s or less appliances or batteries with household waste! Uncertainty (K) : 1.5 m/s...
Page 12
Thoroughly inspect the area where the lawn- IMPORTANT SAFETY INSTRUCTIONS mower is to be used and remove all stones, sticks, wires, bones, and other foreign objects. WARNING: Thrown objects can cause personal injury. Read all safety warnings and all instructions. Failure to follow the warnings and Before using the lawnmower, always visually instructions may result in electric shock, fire and/or inspect to see that the blade and the blade...
Page 13
Check the blades or blade bolts carefully for 13. Do not tilt the mower when switching on the cracks or damage before operation. Replace motor, except if the mower has to be tilted cracked or damaged blades or blade bolts for starting.
Page 14
Do not use a battery pack or tool that is dam- 29. When you use the machine on muddy ground, wet slope, or slippery place, pay attention to aged or modified. Damaged or modified batteries your footing. may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury.
It will Avoid storing battery cartridge in a con- also void the Makita warranty for the Makita tool and tainer with other metal objects such as charger. nails, coins, etc.
Align the hole in the lower handle with the hole Attaching the mulching plug in the upper handle, then insert the bolt from outside, and then tighten the thumb nut from inside. Perform the Open the rear cover, and then remove the grass same procedure on the other side.
The main power lamp lights up in green. To turn off the If no improvement can be found by restoring protection machine, press the main power switch again. system, then contact your local Makita Service Center. NOTICE: If the machine stops due to a cause not described above, refer to the section for troubleshooting.
NOTE: Try a test mowing of grass in a less conspicu- nearest Makita Authorized Service Center. ous place to get your desired height. Install the battery cartridge, and then close the battery cover.
► Fig.42: 1. Knob repairs, any other maintenance or adjustment should NOTE: Supporting the handle makes it easier to be performed by Makita Authorized or Factory Service release the locking pin when pulling the knob. Centers, always using Makita replacement parts.
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to disassemble the machine. Instead, ask Makita Authorized Service Centers, always using Makita replacement parts for repairs.
Only use accessory or attach- ment for its stated purpose. If you need any assistance for more details regard- ing these accessories, ask your local Makita Service Center. • Mower blade •...