To change the LAN settings:
Select Advanced > Setup > LAN Setup.
1.
Enter the settings that you want to customize.
2.
These settings are described in the following section,
Click Apply.
3.
Your changes are saved.
LAN Setup Screen Settings
LAN TCP/IP Setup
IP Address. The LAN IP address of the router.
•
IP Subnet Mask. The LAN subnet mask of the router. Combined with the IP address, the
•
IP subnet mask allows a device to know which other addresses are local to it, and which
must be reached through a gateway or router.
RIP Direction. Router Information Protocol (RIP) allows a router to exchange routing
•
information with other routers. This setting controls how the router sends and receives
RIP packets. Both is the default setting. With the Both or Out Only setting, the router
broadcasts its routing table periodically. With the Both or In Only setting, the router
incorporates the RIP information that it receives.
RIP Version. This setting controls the format and the broadcasting method of the RIP
•
packets that the router sends. It recognizes both formats when receiving. By default, the
RIP function is disabled.
RIP-1 is universally supported. It is adequate for most networks, unless you have an
-
unusual network setup.
R7000 Smart WiFi Router
NETGEAR genie Advanced Home
37
LAN Setup Screen
Settings.