Set Up The Netgear Usb Control Center - NETGEAR R7000 User Manual

Select the language and click OK.
3.
The setup file installs the utility.
On each computer on your network that shares the USB printer, perform the initial setup of
4.
the NETGEAR USB Control Center.
The first time you use the USB printer that is connected to your router, you are asked to
select the USB printer. For more information, see
Control Center
(Optional) Change the default settings.
5.
For more information, see

Set Up the NETGEAR USB Control Center

The first time you access the utility, you are asked to select the printer.
When a USB printer is detected and connected automatically during the initial setup, you
•
must disconnect the printer and wait for the prompt asking you to click Connect.
You might be asked to install the driver for this printer. After the driver is installed, the
•
printer status changes to Available.

To set up the NETGEAR USB Control Center:
On each computer on your network that shares the USB printer, launch the NETGEAR
1.
USB Control Center the same way you launch any application program on your
Windows or MAC computer.
R7000 Smart WiFi Router
on page 75.
Configure the NETGEAR USB Control Center
ReadySHARE Printer
Initial Setup of the NETGEAR USB
61
on page 77.