Table of Contents
Advertisement
Key
Processor
Pusher
1
Feed tube
2
Lid
3
Tool shaft
4
Bowl
5
Detachable drive shaft
6
Power unit
7
Speed/pulse control
8
Safety interlocks
9
Cord storage (at back)
10
Attachments
Not all of the attachments listed below may be
included with your food processor. Attachments
are dependent upon the model variant. Visit
www.kenwoodworld.com for information on how
to buy an attachment not included in pack.
Standard Attachments
Knife blade
11
Dough tool
12
Emulsifying tool
13
4mm Slicing/grating disc
14
Optional Attachments
Citrus juicer (if supplied)
15
A Cone
B Sieve
Grinding mill (if supplied)
16
A Mill Lid
B Grinding Mill Blade Assembly
Plastic blender (if supplied)
17
A Goblet
B Blade Assembly
C Sealing Ring
D Lid
E Filler Cap
Plastic mini chopper/mill (if supplied)
18
A Jar
B Sealing Ring
C Blade Assembly
2mm Slicing/grating disc
19
To Use Your Food Processor
Refer to Illustrations
IMPORTANT
Take care when handling sharp blades,
always hold by the finger grips.
Always fit the bowl and attachment onto
the processor before adding ingredients.
Do not use the lid to operate the
processor, always use the on/off speed
control.
The processor will not operate if the bowl
or lid are not fitted correctly into the
interlock. Check that the feed tube and
bowl handle are situated to the right front
hand corner.
Use the pulse (P) for short bursts. The
pulse will operate for as long as the control
is held in position.
Always switch off and unplug before
removing the lid.
Your processor is not suitable for crushing
or grinding coffee beans, or converting
granulated sugar to caster sugar.
When adding almond essence or flavouring
to mixtures avoid contact with the plastic
as this may result in permanent marking.
1
Fit the detachable drive shaft onto the power
unit.
2
Then fit the bowl by aligning the
bowl with the
clockwise until it locks
3
To assemble your tool (knife blade, dough
tool and emulsifying tool), using the finger
grips place the detachable tool part over
the tool shaft and lower into place, turn the
attachment anticlockwise to lock into place.
4
Fit the assembled tool over the drive shaft.
5
Fit the lid - ensuring the top of the drive
shaft/tool locates into the centre of the lid.
6
Plug in, switch on and select a speed. (Refer
to the Recommended usage chart
7
Reverse the above procedure to remove the
lid, attachments and bowl.
To Use Your Knife Blade
Refer to Illustrations
1
Follow the instructions under 'To Use your
Food Processor'.
Hints and Tips
For coarser textures use the pulse control.
Cut food such as meat, bread, vegetables into
cubes approximately 2cm.
Biscuits should be broken into pieces and
added down the feed tube whilst the appliance
is running.
4
-
C
I
on the
on the power unit, turn
.
O
).
-
C
I
Advertisement
Table of Contents
