Makita SW400MP Original Instruction Manual page 7

ASSEMBLY
WARNING:
Before assembling or adjusting the
equipment, switch off the motor or engine and remove the
spark plug cap or battery cartridge. Otherwise the brushes,
drums, or other parts may move and result in serious injury.
WARNING:
When assembling or adjusting the
equipment, always put it down. Assembling or adjusting the
equipment in an upright position may result in serious injury.
WARNING:
Follow the warnings and precau-
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.
Assembling the attachment
1. Remove the clip from the brush or sweep drum on
the left side of the brush unit or sweep drum unit, and
then remove the brush or sweep drum.
► 1 . Brush 2. Clip
2.
Loosen 3 screws on the gear case.
► 1 . Screw 2. Gear case
3.
► 1 . Pipe 2. Cap
NOTICE:
cap is necessary for storing the attachment.
4.
1
2
► 1 . Pin 2. Pipe 3. Protector 4. Sleeve
NOTICE:
without the pin into the protector and the sleeve.
1
2
7 ENGLISH
Remove 2 caps from both ends of the pipe.
1
Do not dispose of the caps since the
Attach the protector and the sleeve to the pipe.
4
Be sure to insert the end of the pipe
2
1
2
3