Makita SW400MP Original Instruction Manual page 9

9. Attach the brush or sweep drum to the brush unit
or sweep drum unit, and then attach the clip to the
brush or sweep drum.
NOTICE:
When attaching the brushes, be
sure to attach them with the Makita logo facing
outside.
NOTICE:
When attaching the sweep drums, be
sure to attach them in the direction shown in the
figure, so that the sweep drums and the gear case
mesh with each other.
1
► 1 . Sweep drum 2. Gear case
Mounting the attachment pipe
CAUTION:
Always check that the attach-
ment pipe is secured after installation. Improper
installation may cause the attachment falling off from
the power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1. Turn the lever toward the attachment.
► 1 . Lever
2
1
9 ENGLISH
2. Align the pin with the arrow mark. Insert the
attachment pipe until the release button pops up. Make
sure that the position line is on the tip of the arrow mark.
► 1 . Release button 2. Arrow mark 3. Pin 4. Position
line
3. Turn the lever toward the power unit.
1
► 1 . Lever
Make sure that the surface of the lever is parallel to the
pipe.
NOTICE:
Do not tighten the lever without the
attachment pipe inserted. Otherwise the lever may
tighten the entrance of the drive shaft too much and
damage it.
To remove the pipe, turn the lever toward the attach-
ment and pull the pipe out while pressing down the
release button.
Fig.12
► 1 . Release button 2. Lever 3. Pipe
1
2
3
4
1
2
3