Makita SW400MP Original Instruction Manual page 8

5. Make sure that the gear case and the pin on the
pipe are facing up, and then insert the pipe into the gear
case.
► 1 . Gear case 2. Pipe 3. Pin
NOTICE:
Make sure that the gear case and the
pin on the pipe are facing up, and the protector is
attached in the direction shown in the figure.
1 2
► 1 . Gear case 2. Protector 3. Pin
6.
Align the screw hole on the pipe with the hole on
the gear case by rotating the pipe.
1
► 1 . Hole 2. Pipe
2
1
3
3
2
7. Tighten 3 screws on the gear case.
► 1 . Screw 2. Gear case
8. Tighten 2 screws on the protector.
► 1 . Screw 2. Protector 3. Sleeve 4. Gear case
NOTICE:
Make sure that there is no gap
between the gear case and the sleeve, and the
sleeve and the protector.
8 ENGLISH
1
2
1
2
3
4