Grizzly G0656P Instruction Manual page 38

9.
Slide the motor upward, and place the V-belt
around the cutterhead pulley and the motor
pulley.
10. Slide the motor down to rest on the V-belt.
11. Place a straightedge against both pulleys
(Figure 10) and check the alignment of
the two pulleys to make sure that they are
aligned and that the V-belt is straight up and
down (see Figure 11).
Figure 10. Checking belt alignment.
Alignment
Figure 11. Pulleys aligned.
— If the pulleys are aligned, tighten the motor
bracket fasteners and go to Step 15.
— If the pulleys are NOT aligned, perform
Steps 12–14.
12. Remove the V-belt and loosen the motor
mount fasteners (see Figure 9).
Model G0656 (Mfg. since 10/07)
Straightedge
Cutterhead
Pulley
Motor
Pulley
13. Shift the motor horizontally as needed to
align the motor pulley with the cutterhead pul-
ley, then replace the V-belt.
14. Tighten the motor mount fasteners.
15. Secure the infeed and outfeed handwheels
with the cap screws and flat washers already
mounted on the handwheel shafts, as shown
in Figure 12.
Figure 12. Securing the handwheel handle.
16. Secure the handwheel handles to each of the
the handwheels, as shown in Figure 12.
17. Install the fence tilt lever, as shown in Figure
13.
Figure 13. Fence tilt lever installed.
18. Slide the cutterhead guard shaft down through
the mounting hole on the table.
Note: The guard may not fully seat in the hole
initially; however, rotating the guard will allow
the shaft to fully seat in the hole.
-15-