Calibrating The Conductivity Meter - Miele PLW 8616 Operating Instructions Manual

System settings
Calibrating the
conductivity
meter
70
When particularly high demands are placed on the cleaning and final
rinse result, e.g. in chemical analysis, the conductivity meter can be
Adjust conductivity meter
adjusted with the
system is adjusted in the conductivity measuring range from deminer-
alised water to cold water.
Adjustment of the conductivity meter can only be carried out if
there is no load carrier in the wash chamber.
The wash chamber should be rinsed with demineralised water in or-
der to avoid excessively high readings due to the transfer of alkaline
solution.
Press the Adjust conductivity meter

The measurement for demineralised water is performed.
In the display, the message
step is shown, e.g.
Once the measurement is complete, the
Actual
is shown along with the input screen for the manually determ-
ined value.
The door of the infeed side is released for the manual measurement.
Open the door and perform the manual conductivity measurement.

Close the door.

Select the button next to the

meter to open the on-screen keyboard.
Enter the measured value into the on-screen keyboard and confirm

with OK.
Readings with decimal places must be mathematically rounded.
Press the OK button.

The measurement is performed for cold water.
Perform the same work steps as for the demineralised water if the

Cold water conductivity: Actual
The input values for
tem.
Machine functions
The
Adjustment of the conductivity meter can be cancelled using the 
button in the footer. The message
unsuccessful. Please repeat.
button.
Please wait...
Measurement active
Demin. water conductivity: New
message is displayed.
Conductivity ... new
is shown again in the display.
Adjustment of conductivity meter
will appear on the display.
function. The measuring
and the current process
.
Demin. water conductivity:
are applied in the control sys-
para-