Module And Terminal Blocks Identification; Reset Hole - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

Panel Installation
MODULE AND TERMINAL
BLOCKS IDENTIFICATION
To ease wiring of external cables to respective terminal
blocks you will need to decide in which slots of module

carriers each module
Each module is colour coded and the respective colour
coded label from the label set must be fitted to the
module carrier, as illustrated.
Identify the required colour coded label
label set and fit it to the module carrier
location shown as illustrated.

RESET HOLE

Each module has a Reset hole
During commissioning it may be necessary to reset a
Module by inserting a non conductive pin through the

hole to operate a micro switch to reset the module.
44

is to be located.

from the

in the

for engineering use.

1 Loop 1 OUT +VE
2 Loop 1 OUT -VE
3
4 Loop 1 IN +VE
5 Loop 1 IN -VE
1 2 3 4 5
6 7 8 9 10
6 Loop 2 OUT +VE
7 Loop 2 OUT -VE
8
9 Loop 2 IN +VE
10 Loop 2 IN -VE
LOOP OPAL X2


 