Honeywell Farenhyt IFP-2000 Manual page 146

Model IFP-2000/ECS Installation Manual
Type
Function
Selection
STATUS POINT
ECS INPUT
ECS TAMPER
SWITCH
(cont.)
ECS SUPER-
VISORY
CO DETECT SW
OUTPUT PT
AUX CONST
AUX RESET
NOTIF
AUX DOOR
OUTPUT PT
AUX RESET
RELAY
AUX DOOR
LED NUMBER
SLC LED LED FUNCTION
2-WIRE
DETECTOR
MODULE
9-13
Table 9-3: Programming Options for 5815XL Modules
Latching Option
Latching
Non Latching
Latching
Non Latching
Latching
Non Latching
Select Group
Select Group
01-80
Unused
NOTIF
Comments
User also has ECS Event Number 1-8 option for ECS INPUT.
Only available when an ECS-VCM is installed in the system.
CO Detector Switch
Output point, a general use notification type. Use for driving
standard notification appliances.
Use constant power for applications that require a constant auxiliary
power source. Power is always present at constant circuits.
Use for auxiliary power, resettable applications. See Section
4.12.5.3 for a description of how this option operates.
Use for auxiliary power, door holder applications. For example, if
you were using an auxiliary power supply for door holders, you
would use this option. See Section 4.12.5.1 for a description of how
this option operates.
Output point, a general use relay type. Use for applications requiring
a relay, such as fan shutdown, elevator recall, and so on.
Use for auxiliary power, resettable applications. See Section
4.12.5.3 for a description of how this option operates.
Use for auxiliary power, door holder applications. For example, if
you were using an auxiliary power supply for door holders, you
would use this option. See Section 4.12.5.1 for a description of how
this option operates.
For use with SD devices only. 80 sub addresses on LED.
Notification can have group number.
For use with conventional 2-wire detectors.
151430-L8