Grizzly G0937 Owner's Manual page 21

B. CROSS-SLIDE FEED HANDLE
The cross-slide feed should run smoothly, and the scale must rotate with the handle.
If any stiffness occurs, it is probably the result of swarf lodging between the mating surfaces. Undo the
screw securing the handwheel, remove the handwheel, and pull off the collar with the scale taking great
care to retain the small spring plate which sits in a groove beneath the collar.
Clean the assembly and reassemble in reverse order. It may be necessary to hold the spring plate in
place with a small screwdriver, or similar tool, and push down on it to allow the collar to be correctly
located on the shaft.
C. MILL/DRILL HEAD ADJUSTMENTS
Mill/drill head adjustments are made in the same way as those for the cross-slide. The gib screws are to
be found on the right-hand side of the headstock base.
D. TAILSTOCK ADJUSTMENTS
The tailstock is secured by two screws. Loosen these screws to move the tailstock left or right, then
tighten the screws to fix it in position on the bed way.
NOTE:
It is important that the cross-slide and compound slide adjustments are correctly done and that there is
no "sloppiness" of action. Any misadjustment will have a serious effect on the quality of your work, as
movement will all be transferred to the tool tip. It is vital that there is as little movement of the tool as
possible.
18