Table of Contents
Advertisement
5.2 Display
A. Temperature indicator
5.3 Switching on and off
To switch on the appliance:
1. Insert the plug into the wall socket.
2. If the display is off, tap and hold the
Temperature decrease key and
Light key for 3 seconds.
The display shows the default set
temperature 12°C.
To switch off the appliance, repeat step 2
and pull out the plug from the wall
socket.
To select a different temperature, refer to
the "Temperature regulation" section.
5.4 Temperature regulation
The default set temperature
for the wine cabinet is 12°C.
The temperature can be
adjusted between +5 and
+20°C.
To set the temperature, tap the
Temperature increase or decrease key
for the compartment:
• Single tap shows the current set
temperature.
• Second tap increases or decreases
the temperature by one degree.
• To speed up the selection, tap and
hold the Temperature increase or
decrease key until you reach the
desired temperature.
A
By default, the temperature
digits show the current
temperature. When you tap
once or start selecting a new
setting, the displayed digits
blink. After 3 seconds
without tapping the keys, the
digits stop blinking and the
current temperature is
displayed.
To set the right temperature for each
type of wine, refer to the "Daily use"
chapter.
5.5 Light setup
Tap the Light key once to turn the light
on or off. The default light setting is 1A
for the light behaviour and 9L for the light
brightness.
The light has no negative
effect on the quality of wine.
You may adjust behaviour and
brightness of the light.
To set the light behaviour or brightness:
1. Tap and hold the Light key for 3
seconds to enter the light setting
menu.
2. Light behaviour A appears. Tap the
Light key again to go to the light
brightness L.
3. Tap the temperature regulators
repeatedly to set the desired light
behaviour or brightness.
Light behaviour (A):
• 1A door open - lights on at the highest
dimming level, door closed - lights
turn off,
ENGLISH
9
Advertisement
Table of Contents
