Table of Contents
Advertisement
Problem
The compressor operates
continually.
The light does not work.
Too much vibration.
The appliance is noisy.
Water flows on the rear plate
of the appliance.
Water flows inside the wine
cabinet.
Water flows inside the wine
cabinet.
The temperature in the wine
cabinet is too low or too
high.
Possible cause
The circuit breaker tripped
or a blown fuse.
Temperature is set incor‐
rectly.
The room temperature is
too high.
The door is opened too of‐
ten.
The door is not closed cor‐
rectly.
The light is turned off.
The appliance is not plug‐
ged in.
The circuit breaker tripped
or a blown fuse.
The lamp is defective.
The light button is not op‐
erating.
The appliance is not sup‐
ported properly.
The appliance is not sup‐
ported properly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The appliance drain is
clogged.
Products prevent that wa‐
ter flows into the water col‐
lector.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
ENGLISH
Solution
Turn on the circuit breaker or
change the fuse.
Refer to the "Operation" chap‐
ter.
Refer to the "Installation"
chapter.
Do not keep the door open
longer than necessary.
Refer to the "Closing the door"
section.
Turn on the light. Refer to the
"Light setup" section.
Connect the appliance.
Turn on the circuit breaker or
change the fuse.
Contact the Authorised Serv‐
ice Centre.
Contact the Authorised Serv‐
ice Centre.
Check if the appliance stands
stable.
Check if the appliance stands
stable.
This is correct.
Clean the appliance drain
hole. Refer to the "Cleaning
the drain" section.
Make sure that products do
not touch the rear plate.
Set a higher or lower tempera‐
ture.
Refer to the "Closing the door"
section.
15
Advertisement
Table of Contents
