Operation - Makita CE002G Instruction Manual

2. Insert the pins of hose clamp into the holes of
clamp holder.
Make sure the two pins are fit in the holes.
2
3
Fig.14
► 1 . Pin 2. Hole 3. Clamp holder
3.
To remove the hose clamp, follow the installation
procedure in reverse.
Box wrench storage
When not in use, store the box wrench as shown in the
figure to keep it from being lost.
1
Fig.15
► 1 . Box wrench

OPERATION

Checking the lower guard function
Remove the battery cartridge.
Retract the lower guard manually to the end and
release it. The lower guard is properly functioning if;
1
—
—
Fig.16
► 1 . Lower guard
If the lower guard is not functioning properly, check if
dust is accumulated inside of the wheel cover.
Some dust may be removed by retracting and returning
the lower guard several times.
If the lower guard is not functioning properly even after
removing dust, have your machine serviced at a Makita
service center.
Notification about the abnormal
noise
NOTICE:
wheel. Otherwise malfunction, abnormal noise, or
breakage may occur.
Even if the diamond wheel is new and without distortion,
the diamond wheel may make abnormal noise such as
metal friction when the tool is running at low speed. This
is not malfunction of the tool.
Some kind of diamond wheel may make abnormal noise
when the tool running at low speed. It is because the
diamond wheel and the wheel cover are positioned very
close for efficient dust collection.
Run the tool at full speed and operate proper cut-
ting. The abnormal noise will be relieved.
14 ENGLISH
it is retracted without any hindrance and;
it automatically returns to the original position.
1
Do not use distorted or old diamond
1