Installing Or Removing Battery Cartridge - Makita UT002G Instruction Manual

Cordless mixer
Hide thumbs Also See for UT002G:
Table of Contents

Advertisement

Available languages

Available languages

2.
Tighten the chuck by hand, and then place the
chuck key in each of three holes and tighten it clock-
wise. Be sure to tighten the chuck key at all three holes
evenly.
1
Fig.6
► 1. Chuck key 2. Chuck
3.
To remove the shaft, turn the chuck key coun-
terclockwise at one of the holes, and then loosen the
chuck by hand.
4.
When not in use, store the chuck key as shown in
the figure to keep it from being lost.
1
Fig.7
► 1. Chuck key
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
CAUTION:
Do not use this tool with the
battery adapter. If you connect the battery adapter
to the tool, the battery cover cannot be closed, and
using the tool with battery cover opened may cause
an injury.
CAUTION:
Be careful not to pinch your fin-
gers when opening or closing the battery cover.
NOTICE:
Install a battery cover that matches the
size of the battery.
Open the battery cover while pressing the button on the
battery cover.
2
Fig.8
► 1. Button 2. Battery cover
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
Fig.9
► 1. Red indicator 2. Button 3. Battery cartridge
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
After installing the battery cartridge, close the battery
cover securely.
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
7 ENGLISH
1
CAUTION:
Always install the battery cartridge
CAUTION:
Do not install the battery cartridge
2
1
2
3
1

Advertisement

Table of Contents
loading

Table of Contents