Makita DCU603 Instruction Manual page 25

DCU605
► Fig.3
1 Control panel
3 Switch trigger
5 Rear wheel lock
7 Battery box
9 Rear wheel
11 Front lamp
13 Flat bucket
CONFIGURATION OF
MACHINE
When the bucket is installed
► Fig.4
1 Bucket
3 Base unit
When the carrier is installed
► Fig.5
1 Carrier
3 Base unit
When the flat bucket is installed
► Fig.6
1 Flat bucket
ASSEMBLY
CAUTION:
Always be sure that the machine
is switched off and the battery cartridges are
removed before carrying out any work on the
machine.
Before installing or removing the carrier, bucket, flat
bucket, or dump unit, be sure to lock the brake lever.
To lock the brake lever, pull and hold the brake lever,
then pull the lock lever, and then release the brake lever
while pulling the lock lever.
► Fig.7: 1. Brake lever 2. Lock lever
2 Beep button
4 Rear lamp
6 Handle
8 Brake lever
10 Front wheel
12 Cap
- -
2 Dump unit
- -
2 Dump unit
- -
2 Base unit
Installing or removing the dump unit
Optional accessory
Installing the dump unit
1.
Take out the dump unit and the handle from the
box.
► Fig.8: 1. Dump unit 2. Handle
2. Insert the pipes of the handle into the dump unit as
shown in the figure, and then tighten 4 bolts securely.
► Fig.9: 1. Bolt 2. Handle
NOTE: When tightening the bolts, lift the handle
slightly.
3. Make sure that the dump unit is locked by pulling
down the handle.
► Fig.10: 1. Handle
4.
Remove the cord cover located in the lower right
corner on the rear of the machine.
► Fig.11: 1. Cord cover
5. Place the dump unit on the base unit by holding
the dump unit with two people as shown in the figure.
► Fig.12
6. Temporarily tighten 2 bolts at the rear of the
machine. Tighten the rest of 4 bolts securely, and then
tighten 2 bolts at the rear of the machine securely.
► Fig.13: 1. Bolt (front) 2. Bolt (rear)
7. Attach the cord cover.
► Fig.14: 1. Cord cover
Removing the dump unit
To remove the dump unit, perform the installation proce-
dure in reverse.
Installing or removing the bucket
Optional accessory
Installing the bucket
1.
Take out the bucket, stays, and front pipe from the
box.
► Fig.15: 1. Bucket 2. Stay 3. Front pipe
2. Insert the front pipe between the upper frame and
lower frame of the dump unit.
► Fig.16: 1. Front pipe
3.
Place the stay on the dump unit, and then tempo-
rarily tighten the bolts with the front pipe together. Install
the other stay to the dump unit in the same way.
► Fig.17: 1. Stay 2. Bolt
4. Place the bucket on the front pipe and left and
right stays.
Place the rubber washer on the hole of the bucket and
insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
► Fig.18: 1. Bolt 2. Rubber washer 3. Flat washer
4. Spring washer 5. Nut
25 ENGLISH