Adjusting The Handle Height - Makita DCU603 Instruction Manual

2
Fig.42
► 1. Brake lever 2. Lock lever
Adjusting the width of the carrier
NOTICE:
Make sure that the side rails and front
rail are fixed securely after tightening the thumb
nuts.
Loosen 6 thumb nuts, and then slide the side rails and
front rail. Tighten the thumb nuts to fix the side rails and
front rail.
Fig.43
► 1. Thumb nut 2. Rail
CAUTION:
Do not slide the rails beyond the
limit mark.
Fig.44

Adjusting the handle height

NOTICE:
1
same height.
The handle height can be adjusted in 7 levels. To adjust
the handle height, loosen 2 knobs, then adjust the handle
height by aligning the hole on the handle with the protru-
sion on the rear frame, and then tighten 2 knobs securely.
Adjust the height of the other handle in the same way.
Fig.45
► 1. Knob
Rear wheel lock
1
You can fix the direction of the rear wheels using the rear wheel lock.
1. Slightly move the machine forward so that the rear
wheels face the direction shown in the figure.
2
Fig.46
► 1. Rear wheel
2. Rotate the rear wheel lock toward the rear.
Fig.47
► 1. Rear wheel lock
21 ENGLISH
Fix the left and right handles at the
1
1
1