Table of Contents
Advertisement
Verifying TCP/IP Properties
After your PC is configured and has rebooted, you can check the TCP/IP configuration using the
utility winipcfg.exe:
On the Windows taskbar, click the Start button, and then click Run.
1.
Type
, and then click OK.
2.
winipcfg
The IP Configuration window opens, which lists (among other things), your IP address, subnet
mask, and default gateway.
From the drop-down box, select your Ethernet adapter.
3.
The window is updated to show your settings, which should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
•
The IP address is between 192.168.0.3 and 192.168.0.254
•
The subnet mask is 255.255.255.0
•
The default gateway is 192.168.0.1
Configuring Windows NT, 2000 or XP for IP Networking
As part of the PC preparation process, you need to manually install and configure TCP/IP on each
networked PC. Before starting, locate your Windows CD; you may need to insert it during the
TCP/IP installation process.
Install or Verify Windows Networking Components
To install or verify the necessary components for IP networking:
On the Windows taskbar, click the Start button, point to Settings, and then click Control Panel.
1.
Double-click the Network and Dialup Connections icon.
2.
If an Ethernet adapter is present in your PC, you should see an entry for Local Area
3.
Connection. Double-click that entry.
Select Properties.
4.
Verify that 'Client for Microsoft Networks' and 'Internet Protocol (TCP/IP)' are present. If
5.
not, select Install and add them.
Select 'Internet Protocol (TCP/IP)', click Properties, and verify that "Obtain an IP address
6.
automatically is selected.
Preparing Your Network
Reference Manual for the Model HR314 802.11a Hi-Speed Wireless Router
3-5
Advertisement
Table of Contents
Troubleshooting
