Table of Contents
Advertisement
Reference Manual for the Model HR314 802.11a Hi-Speed Wireless Router
Local Area Network (LAN) Hardware Requirements
The HR314 is intended for use in a network of personal computers that are interconnected by
802.11a-compliant wireless adapters or twisted-pair Ethernet cables.
PC Requirements
To install and run the HR314 over your network, each computer must have the following:
•
An installed 802.11a-compliant wireless adapter
OR
•
An Ethernet Network Interface Card (NIC).
For interconnecting your wired Ethernet devices, the HR314 provides a 4-port switch capable
of either 10 Mbps or 100 Mbps operation. Links operating at 100 Mbps must be connected
with Category 5 cable.
DSL or Cable Modem Requirements
The cable modem or DSL modem must provide a standard 10 Mbps (10BASE-T) Ethernet
interface. The router does not support USB modems.
Connecting the Router
Before using your router, you need to do the following:
•
For wireless communications, identify a suitable location to place the router according to the
guidelines in
"Placement of the Router to Optimize Wireless Connectivity" on page
prepare your wireless devices as described below.
•
Connect your cable or DSL modem to the Internet port of the router (see
•
Connect your local Ethernet network to the LAN port(s) of the router (see
•
Connect the power adapter (see
Note: The Resource CD included with your router contains an animated Installation Assistant to
help you through this procedure.
2-4
page
2-6)
2-3. Then,
page
2-5).
page
2-5).
Setting Up the Hardware
Advertisement
Table of Contents
Troubleshooting
