Honeywell OneWireless XYR 6000 Professional Installation Manual page 31

Notes for Table 7-1 andTable 7-2:
1. The Maximum TX Power Setting values given in
by the Radio circuit within the RF Module. These Maximum TX Power Setting values do not include
antenna gain nor do they include the losses caused by cables and connectors. When these external gains
and losses are included, then using these Maximum TX Power Setting values ensures that the XYR 6000
EIRP will not exceed the maximum EIRP limits that are given in
2. The values in the above tables have been determined through agency certification testing.
3. The following shall apply for antenna type, frequency range, application/usage and agency/country
compliance:
•
Antenna gains above the maximum values shown shall not be used.
•
Cable length/loss below the minimum values shown shall not be used.
•
Maximum overall radio output power shown shall not be exceeded.
•
Maximum EIRP values shown above shall not be exceeded.
France
4. restricts outdoor use to 10mW (10 dBm) EIRP in the frequency range of 2,454-2,483.5 MHz.
Installations in France must limit EIRP to 10 dBm for operating modes utilizing frequencies in the range of
2,454 – 2,483.5MHz. For this reason, Honeywell does not recommend configuring frequency hopping
modes that use this frequency range. For installations in France, use only the following OneWireless
Frequency Hopping (FH) Mode Selections: EU Channel #1, EU Channel #7 and NA/EU Channel 3 (FH
Mode selections #4, 5 and 10).
Kuwait
5. has licensed the Kuwait Oil Company (KOC) to use the Kuwait Reserved Band (2485 – 2499
MHz). For installations in Kuwait for KOC, use the following OneWireless Frequency Hopping (FH)
Mode Selection: Kuwait Reserved Band (FH Mode selection #8), no other selections are permitted. This
selection is licensed for use in Kuwait only by KOC, it should not be used for other applications and
locations.
Industry Canada Compliance Statement
6.
antenna types listed in this document, and having a maximum gain of 14 dBi. Antenna types not included
in this list or having a gain greater than 14 dBi are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.
Japan
7. restricts maximum EIRP to 12.14 dBm/MHz (equivalent to 15.14 dbm) EIRP. For this reason,
Japan restricts the TX Power setting to 10 dBm (equivalent to 7 dBm/MHz) for all models and does not
permit changes to this value.
Brazil Anatel
8.
Other Anatel approved antennas can be used in Brazil, consult local suppliers for availability.
When using non-Honeywell supplied antennas, adjust TX Power such that the EIRP limit given in Table 7-
2 is not exceeded.
Revision 3 OneWireless XYR 6000 Transmitter Professional Installation Guide
September 2012
does not permit the use of Honeywell supplied antennas of greater than 6 dBi gain.
7. Equivalent Isotropically Radiated Power (EIRP)
Table 7-1 and Table 7-2 represent the power produced
Table 7-1
: This device has been designed to operate with the
7.1. EIRP LIMITS
and Table 7-2.
21