Table of Contents
Advertisement
Fig. 2-1-7
1. Remove Strain relief by unscrewing
M4x16 Pan head screw.
Fig. 2-1-8
1. Loosely tighten with Receive washer A and Hex nut M10-17/ Hex nut M10-14 to prevent Rotor from falling out.
Loosely tighten Nylon cutting head instead of the hex nut if Nylon cutting head is used.
2. Put Motor housing on 1R350, and release
the press-fitting condition of Stator ass'y
and the shaft of Rotor slightly with 1R045.
ﾄ
Shaft of Rotor
Stator ass'y
Stator ass'y is
slid upward from
Shaft end of Rotor.
M4x16 Pan
head screw
Strain relief
Receive washer A
Hex nut M10-17/ Hex nut M10-14
Rotor
3. Pry Stator ass'y with
two pieces of 1R263.
1R045
1R263
Motor
housing
1R350
5. Press Ball bearing 607ZZ with 1R286 to remove it from Stator ass'y.
2. Pull out Motor housing.
Motor housing
4. Pull out Stator ass'y
from the shaft of Rotor.
Stator ass'y
Shaft of Rotor
1R286
Stator ass'y
Ball bearing 607ZZ
P 6/ 19
Advertisement
Table of Contents
