Table of Contents
Advertisement
(2) Remove Protector. (Fig. 2-1-4) And then, disassemble Motor housing section. (Fig. 2-1-5 as below and Fig. 2-1-6 in
page 5, Figs 2-1-7/ 2-1-8 in page 6, and Fig. 2-1-9 in page 7)
Fig. 2-1-4
< Protector>
1. Disassemble Protector by loosening two
M5x20 Hex socket head bolts.
Note: No need to remove Hex socket
head bolts completely.
M5x20 Hex socket
head bolts (2 pcs.)
Fig. 2-1-5
1. Loosen M5x25 Hex socket head bolt.
Remove three M5x20 Pan head screws.
3. Remove Controller B and Inner cover by unscrewing two M4x16 Pan head screws.
M4x16 Pan head screw (2 pcs.)
4. Disconnect the connectors of
Controller B.
Connectors of Controller B
2. Disassemble Protector clamp by unscrewing
two M5x16 Hex socket head bolts with WR*.
M5x16 Hex socket head bolts with WR* (2 pcs.)
Protector
Protector clamp
M5x20 Pan head screw (3 pcs.)
Controller B
Note: Lead wires connected with Insulated connectors 5.5-SD
can be disconnected without cutting lead wires.
(Fig. 2-1-6 in page 5)
Top cover
2. Remove Top cover.
M5x25 Hex
socket head bolt
Inner cover
5. Cut three Insulated connectors 5.5-SD
at the position marked with red lines.
Insulated connectors 5.5-SD (3 pcs.)
P 4/ 19
*W...Spring washer
R....Flat washer
Advertisement
Table of Contents
