Honeywell 7800 Series Product Data page 30

7800 SERIESS7800A2142 4-Line LCD Keyboard Display Module
Call for Service Setup
Setup of the Call for Service lockout message feature is accessed from the Display Menu
(see the Fig. 34). The feature permits a custom message to be displayed in place of the
standard lockout message. The custom message can be up to 8 lines of 20 characters per
line. The first line is not editable and matches with the first line of the standard lockout
message. For a full list of available text and characters, refer to table 8.
First line of call for service message matches standard lockout message so that the lockout
detail command can be positioned on the line.
Fig. 34. Call for Service setup menu
The lines of the message are displayed on the menu, and if more than 2 lines are in the
message, the last lines can be seen by scrolling down the page (see Fig. 35).
Fig. 35. Call for Service message
The up and down arrow buttons are used to scroll through the menu lines. A "Next page"
symbol is displayed on the menu line if it is selectable for an action (all menu lines except
for the message itself). When a selectable menu line has focus (is highlighted) and the
right arrow or OK button is pressed, the following actions occur:
• "Display option" – enable/disable this feature
• "Test message" – view message in operation
• "Edit message" – edit the message
The user must be logged in before navigation to the "Display option" and "Edit message"
pages occur. If the user is not logged in, the user is asked to log in. The left arrow button is
used to exit this page and return back to the Display Menu page. The Home button exits
this page and goes to the Home page.
The Call for Service feature is turned on (enabled) or off (disabled) by editing the "Display
option" (see next figure). The up and down arrow buttons are used to scroll to the desired
setting: "Enabled" or "Disabled". To commit the change the right arrow button is used to
tab to the "Yes" command and the OK button is pressed to save the selected setting. If the
setting should not be saved, scroll down to the "No" command and press the OK button. In
both cases control returns back to the Call for Service menu.
Fig. 36. Enable/disable Call for Service
Changing the contents of the message is initiated by selecting the "Edit message" line
(see Fig. 37). Since the first line of the message is fixed, i.e., not editable, the input focus
is positioned on the first character position of the second line. Up to 20 characters can be
entered for each line. Up to 7 lines (excluding the first line) can be edited, lines 2 through 8.
Lines at the bottom that are blank are not displayed in the message. The current message
text is displayed when the page is initially entered.
32-00110-07
FIRST TWO
LINES OF
MESSAGE
30
FIRST TWO
LINES OF
MESSAGE
LAST
FIVE
LINES